NUTRIBULLET Portable Blender - Product Components and Setup; Whats Included; Assembly Guide; Before First Use

Before fi rst use.
CLEAN UNIT:
See Care and Maintenance
section on page 24.
CHARGE UNIT:
Plug the smaller end of the
included USB-C Cable into the
slot right below the Power
button (on the front of the
Motor Base) and the larger
end of the cable into the
General Purpose Power Supply.
• We recommend fully
charging the unit before
using it for the fi rst time.
It takes 60-90 minutes to
reach a full charge.
Please see LED Status Light
Indicator section on pages 18-20.
WARNING! Do not charge if your
unit or the USB-C port is wet to
avoid risk of fi re or bodily injury.
1716
Assembly guide.What’s included.
590ml cup
to-go lid
motor base
590ml cup
USB-C
charging cable
blade assembly
measurement markings
alignment marking
LED status light
power button
motor base
USB-C charging Cable
16
20
400
500
MAX
ml
100
200
300
8
4
12
20oz cup
USB-C charging slot
Spout lid with handle
Product configurations may vary. To see our full list of nutribullet
®
accessories
please visit bulletbrands.com.au / bulletbrands.co.nz.
16
20
400
500
MAX
ml
100
200
300
8
4
12
locking latch
release button