NUTRIBULLET Portable Blender - Vehicle and Storage Safety; Cleaning and Care; Charging Procedure

98
• Do not leave your
nutribullet
®
Portable
Blender inside your
vehicle, especially
in the summer or winter.
Prolonged exposure
to extreme temperatures
can cause the
batteries to rupture,
or explode
• Periodically inspect your
nutribullet
®
Portable
Blender components
for damage or wear
that may impair proper
functioning or create a
safety hazard.
• Be aware of possible
hazards when
charging, using, or
storing your nutribullet
®
Portable Blender.
• Do not use this blender
for anything other its
intended use.
• Never operate your
nutribullet
®
Portable
Blender if the Cup
is empty.
• Do not insert any
object other than the
appropriate charger
into the USB-C port.
Do not allow dust to
accumulate inside
the port.
• Do not crush, drop, or
damage the Motor
Base. Do not operate
if the Motor Base
is damaged in any
manner. Contact
Customer Service for
assistance by visiting
bulletbrands.com.au /
bulletbrands.co.nz.
• Use only nutribullet
®
attachments/
accessories specifically
designed for your
nutribullet
®
Portable
Blender. Always use
genuine nutribullet
®
replacement parts
and accessories.
Aftermarket parts are
not made to nutribullet
®
specifications and may
damage your unit or
cause serious injury.
• The use of attachments
including canning jars,
is not recommended by
the manufacturer may
cause a risk or injury
to persons.
• Do not attempt to clean
the Motor Base by
immersing in water or
other cleaning liquids.
Only gently wipe and
dry with a clean cloth.
• Only the Cup and Lid
are dishwasher safe on
Top Rack without the
heat or sanitize cycle.
NEVER PLACE THE
MOTOR BASE IN THE
DISHWASHER.
Modification, improper
use, and failure to
follow instructions can
increase the risk
of serious personal
injury, death, or
property damage.
CHARGING YOUR
PORTABLE BLENDER
The blender’s battery
can be charged using
the USB cable provided
and a compatible
power supply unit (PSU).
Charging the battery
using an incorrect PSU
can cause damage to
the battery, including
overheating, that can
lead to fires.
• Place the blender on a
flat surface close to the
USB power outlet.
• Connect the motor
base to the USB power
outlet port by using the
USB cable supplied.
Ensure the cable is
fully unwound.
• Disconnect the USB
cable from the USB
port and the motor
base once the portable
blender is charged. If
using a USB PSU, switch
o the power from the
power point and unplug
the USB power adaptor
prior to disconnecting
the USB cable.
• Use only approved
power supplies rated
100V to 240V certified
for General Purpose use
to charge this device.
The PSU’s rated output
should be 5V 2A MAX.
Do not use non
approved PSU’s.
WARNING!