NUTRIBULLET RX NB-301 - Page 6

1110
after 30 seconds. Before
placing back on motor
base, open pitcher as
needed to scrape down
the ingredients to the
center of the pitcher.
Place pitcher back on
motor base and continue
to process in 30 second
increments until desired
consistency is reached.
• To prevent leakage,
always align and hand-
tighten or use blade
remover to tighten the
blade to the nutribullet Rx
®
cup prior to inverting it
and placing the assembly
on to the motor base.
• To turn on the nutribullet
®
:
plug the motor base into
an electrical outlet. Press
the power button, located
90˚ to the left side of the
n-Button. This will cause
the power button glow
blue. Next, place the cup
blade-side-down onto
the motor base. This will
activate the nutribullet
Rx
®
’s smart technology
function, causing the
n-Button at the front of
the unit to glow green.
• Once activated, the unit
will run for 1 minute in
regular smoothie mode
before it automatically
turns o. The n-Button will
stop glowing green at the
end of the 1-minute cycle.
To turn o completely
before the cycle is
complete, either lift the
cup o of the base, or
press the power button,
located 90° to the left
side of the n-Button. The
power button will extend
from its recessed position
and the blue light will no
longer be lit, signifying the
power is o.
• In smoothie mode, you
will notice there are
2 phases within each
cycle. The motor will slow
down half way through
the cycle to allow the
ingredients to settle for
improved processing. It
will then power up again
to finish the cycle. This is
a normal function of the
nutribullet Rx.
• Turn the nutribullet Rx
®
o
after each use. Depress
the power button, located
90˚ to the left side of
the n-Button. The blue
light will stop glowing,
signifying power is o.
POWER OFF
INSTRUCTIONS
• To turn o the machine
at anytime during the
smoothie cycle (indicated
by the green glowing
n-Button), depress the
power button, located
90° to the left side of the
n-Button and simply
lift the cup o motor
base. When the vessel is
removed from the motor
base, only the green
n-Button light will turn
o. When the power o
button is pressed, the blue
light will turn o and the
blade will stop spinning.
To turn o machine at any
time during souperblast
mode (indicated by
the orange glowing
n-Button), press the
power o button, located
90˚ to the left side of the
n-Button and simply lift
the souperblast pitcher
o the motor base. When
the vessel is removed from
the motor base, only the
orange n-Button light will
turn o. When the power
o button is pressed, the
blue light will turn o
and the blade will stop
spinning. Always press the
power o button when
machine is not in use.
SAFETY WARNINGS
FOR EXTRACTING
SOUPS
Warning!: Only use the
vented souperblast pitcher
and two-piece lid while
operating the nutribullet
Rx
®
in souperblast mode.
The souperblast pitcher
is specially vented to
release pressure as the
soup mixture heats. Other
vessels are unvented and
may rupture and cause
personal injury if misused
in souperblast mode.
• To prevent overheating:
do not repeat souperblast
mode for the same
hot soup. If more heat
is required, place the
contents in a microwave-
safe container and
continue heating to
desired temperature. To
make a new soup, empty
old contents, add new
ingredients and wait 3-4
minutes before returning
the vessel to the motor
base to start a new
smart technology cycle.