NUTRIBULLET RX NB-301 - Page 7

1312
• To prevent overheating,
do not run the nutribullet
Rx in souperblast most
for more than 2 cycles
total without allowing
the motor base and
souperblast accessories
to cool for 30-60 minutes.
• If motor base does not
shut o after one (1)
7-minute cycle during
souperblast mode,
depress the power button,
located 90° to the left side
of the n-Button or simply
lift the souperblast pitcher
o of the motor base.
• Motor base is equipped
with an internal thermal
breaker that shuts o the
motor base when the unit
overheats. If the motor
base overheats and shuts
o, unplug the motor
base or press the power
button, located 90° to the
left of the n-Button and
let it cool for an hour or
more before attempting
to use it again. Motor
base will reset when the
unit is powered o and
the thermal breaker has
cooled down suciently.
HEAT CAUTIONS
• During souperblast mode,
the contents inside can
reach up to about 70°C /
150°F through the friction
of the rotating blade.
• Keep hands and other
exposed skin away from
the lid opening to prevent
possible burns during
souperblast mode.
• Do not remove the lid
during processing of
soup—ingredients will
become hot and may
splash out and cause
injury.
• Do not touch souperblast
pitcher directly with
hands after souperblast
mode! The souperblast
pitcher surface, blades
and coupling gear will
be hot!
• Always use appropriate
heat resistant pads on
the handle to hold the
souperblast pitcher and
to support the bottom of
the container.
• Carefully open
souperblast pitcher lid
after souperblast mode,
as escaping steam and
moisture may cause
scalding burns.
• Always attach blade to
souperblast pitcher and
hand tighten or use the
blade remover to tighten
the blade to prevent
leakage prior to adding
ingredients into the
pitcher.
• Never use the extractor
blade to blend without
liquid as doing so may
damage the blade or
motor.
• Do not use the
souperblast pitcher on the
motor base without the
black lid and clear vent
top in place when running
the nutribullet Rx
®
.
• To turn the nutribullet Rx
®
on in souperblast mode
using smart technology,
plug the motor base
into an electrical outlet.
Press the power button,
located 90˚ to the left
side of the n-Button. The
power button will glow
blue, signifying the power
is on. Next, place the cup
blade-side-down onto
the motor base. This will
activate the nutribullet
Rx
®
’s smart technology
function, causing the
n-Button at the front of
the unit to glow green.
• Press the green n-Button
down for 2 seconds until
it glows orange. This will
indicate that souperblast
mode has begun. The unit
will run in souperblast
mode for about 7 minutes
before automatically
turning o. Once o,
simply lift the souperblast
pitcher o of the motor
base.
• The motor will run in
3 phases during the
7-minute cycle. It
will slow down twice
throughout the cycle to
allow the ingredients
to settle for improved
processing. This is a
normal function of the
nutribullet Rx.
• The contents inside can
reach up to about 70°C /
150°F through the friction
of the rotating blade.
• If you wish to process
your soup for less than
the programmed time,
you may simply lift o the
souperblast pitcher or
press the power button,
located 90˚ to the left
side of the n-Button.