1514
• Always allow it to come
to a complete stop prior
to adding additional
ingredients during the
processing period.
• Always depress the
power button when not
in use. The blue light will
stop glowing, signifying
the power is o. With an
internal thermal breaker
that shuts o the motor
base when the unit
overheats. If the motor
base overheats and shuts
o, unplug the motor
base and press the power
button, located 90° to the
left of the n-Button and
let it cool for an hour or
more before attempting
to use it again. motor
base will reset when the
unit is powered o and
the thermal breaker has
cooled down suciently.
CLEANING
SAFEGUARDS
•
After making a smoothie
or souperblast, the
blade must be cleaned
immediately.
• Always unplug motor
base and depress the
power button prior to
cleaning, assembling or
disassembling.
• Never submerge the
motor base in water or
place it in the dishwasher.
Wipe o any debris
inside the motor base
immediately to keep it in
good working order.
• Do not wash the blades
in the dishwasher as
elevated temperatures
can damage gasket seals.
• Do not remove the rubber
liner inside the motor
base. To clean, unplug
first, then wipe with a
sponge moistened with
warm water.
• The nutribullet
Rx
®
cups
can be washed in the
dishwasher and should be
washed on the top rack
of the dishwasher using
the normal (not sanitize)
cycle.
• The nutribullet
Rx
®
cups
and blades should not
be emmersed in boiling
water for any reason as
this will warp the plastic
and damage gaskets.
• Blades are sharp! Use
care when cleaning
blades to avoid injury!
Rinse blades immediately
after each use to prevent
debris from drying
and sticking to blade
components. If necessary,
use included brush to
loosen any debris around
blades, gaskets and blade
housing threads with care.
• Handwash only with mild
dish soap and warm
water (not hot).
• Dry immediately.
• For tough debris, fill the
cup ½ full with room
temperature (not hot),
mild soapy water. Then,
simply twist on the blade,
pop it on the base and
give it a run for 30-45
seconds. Follow up with a
thorough brushing..
• When washing blades,
do not attempt to remove
the gasket ring. Simply
hand wash the blades in
warm, mild soapy water.
Attempted removal of the
gasket may permanently
damage the blade
configuration and cause
leakage. If in time a
gasket becomes loose or
damaged, please contact
customer service for a
replacement nutribullet
Rx
®
blade holder at:
www.nutribullet.mx
.
STUBBORN CLEANUP
• If ingredients dry inside
the nutribullet
Rx
®
cups
or souperblast pitcher,
make your cleanup a
snap by filling the cup
about 2/3 full with room
temperature soapy
water and screw on the
extractor blade and if
using the souperblast
pitcher, put on lids. Place
the cup assembly on the
nutribullet
Rx
®
motor base
for about 20-30 seconds.
This will loosen the stuck
ingredients, and with a
light scrub and rinse in
warm water, you’ll be
all done.
To Next Page
Loading...
