4
IMPORTANT SAFEGUARDS
Please read all of these instructions thoroughly.
When using electrical appliances, basic safety precautions should always be followed
including the following:
• Read all instructions.
• To protect against risk of electrical shock DO NOT immerse cord, plugs, portable
appliances, or milling unit in water or other liquid.
• Close supervision is necessary when any appliance is used by or near children.
• Unplug from outlet when not in use, before cleaning, putting on, or taking o parts.
• Avoid contacting moving parts.
• Do not operate with a damaged cord or plug or after the appliance malfunctions, or
is dropped or damaged in any manner. Return appliance to the nearest authorized
service facility for examination, repair, or electrical or mechanical adjustment.
• The use of attachments not recommended or sold by the manufacturer may cause
re, electric shock, or injury.
• Do not use outdoors.
• Do not let cord hang over edge of table or counter.
• Do not let cord or unit contact hot surface, including the stove.
• Do not unplug from electrical outlet by pulling on the cord. To unplug, grasp the plug
and pull.
• Do not put your ngers or other foreign objects into any of the mill's openings while
it is in operation.
• Do not leave mill unattended while in use.
• Do not clean by inserting pointed objects into milling chamber or using running water.
SAVE THESE INSTRUCTIONS
NUTRIMILL
®
CLASSIC SAFETY INSTRUCTIONS
• Always be sure the separator cup is properly attached before milling.
• Always be sure the air lter is in place before milling.
• Always be sure the hopper extension ring is removed from the inside of the bowl
before milling.
• Always be sure your our bowl is positioned correctly before milling.
• Always check your grain for foreign objects before milling. Do not use grain that has
not been properly cleaned before packaging / or cleaned by the grain supplier or
packager. We recommend purchasing and using grain from a reliable source.
• Do not over-ll the hopper. It is easy to empty the our canister and continue milling.
• Do not mill damp, wet or oily grains.
• Always clean the lter after milling by tapping out excess our.
• All service and repairs must be done by an authorized service center or warranty will
be void. For service information, see the warranty information on the last page of this
manual.
To Next Page
Loading...
Need help?
General