CAUTION!
Read Before Installing
• The recommended pressure setting is 80 psi (5.6 bar). Install
a pressure regulator before the housing inlet if water pressure
may exceed the Maximum PSI Rating:
MAXIMUM PSI RATING - 100 (6.8 BAR)
• Properly seat the O-Ring inside housing.
• Confirm that the cartridge is inserted properly inside housing
body (large by-pass holes at top).
• Softener MUST be installed vertically.
• Verify that inflow and outflow are properly attached to inlet
and outlet ports, as marked on housing head.
1
To Next Page
Loading...