The NuWave On-The-Go Blender (Model 28401) is a portable, rechargeable, and self-cleaning blender designed for household use. This owner's manual provides essential information for safe operation, usage, maintenance, and troubleshooting.

Function Description:

The NuWave On-The-Go Blender is designed to blend various ingredients, primarily for making cold drinks and smoothies. It is a portable device, allowing users to prepare beverages on the go. The blender operates on a rechargeable battery and features a self-cleaning function for convenience. It is intended for household use only and should be used with a Listed/Certified ITE Power Supply.

Important Technical Specifications:

Model No: 28401
Voltage: DC7.4V
Power: 70W
USB Cable: Type-C
Charging Time: 4 - 5 hours
Blending Cycle: 30 seconds per cycle, with a 2-minute wait time before the next cycle.
Operating Time (fully charged): Up to 30 minutes or approximately 60 cycles.
Storage Temperature Range: -23°F to +95°F (-30°C to +35°C)
Relative Humidity for Storage: 25% to 75%

Usage Features:

Portability: The compact design and rechargeable battery make it suitable for on-the-go use.
Rechargeable: The blender is powered by a built-in battery, charged via a USB-C cable. The cable can be connected to any mobile phone power bank or mobile power bank with a USB-A input. The blender lights up red while charging and turns blue when fully charged.
Blending Process:
1. Ensure the Jar is properly attached to the Power Base.
2. Cut solid foods into small chunks before blending.
3. First, add liquids to the Jar.
4. Then, add solids and/or ice.
5. Secure the Strainer on the Jar, followed by the Lid.
6. Press the Power button twice to begin blending.
Strainer: An optional strainer is included to filter out chunky pieces from blended ingredients.
Safety Features:
- Equipped with a safety sensor that prevents the blades from spinning when the jar is detached.
- The blender will flash red-blue-red-blue when the Jar is not attached.
- Automatic shutdown after a 30-second blending cycle.
- Requires a 2-minute wait time between cycles to prevent overheating.
Jamming Prevention: If blades become jammed, turn off the blender, turn it horizontally, and gently shake. If still jammed, turn it upside down and gently shake.
Ingredient Guidelines:
- Do not blend liquids over 120°F/49°C to prevent damage and leaks.
- Avoid overloading; always leave room at the top of the Jar.
- For best results, liquid and fruit mix should fill more than 20% of the Jar.
- Not a shaved ice machine. Use frozen fruits and refrigerated beverages, or add crushed ice (10% of total capacity) and water/liquids (80% of volume).
- Do not blend ice cubes or hard objects without adding water or liquids, as this may damage the blades.
- Do not run the blender without ingredients in the Jar to prevent motor burnout.
- Avoid storing blends for long periods, as sugars can ferment and create pressure.
Safety Interlocks: Do not attempt to defeat any safety interlock mechanisms.

Maintenance Features:

Fast Cleaning: Add warm soapy water to the Jar, press the Power button twice, and rinse.
Deep Cleaning:
1. Remove the Lid and Strainer, as well as the attached silicone rings.
2. Wash them with warm, soapy water using a brush, sponge, or wet towel.
3. Allow to dry completely.
Power Base Cleaning: Do not pour water directly onto the Power Base. Use a wet towel to clean the exterior, inside, and blades. Do not immerse the Power Base in any liquid.
Storage: When not in use, store the Jar on the main unit. Store the product in a clean, dry, ventilated room within the specified temperature and humidity ranges.

Important Safeguards and Warnings:

General Safety:
- Use only with the provided USB-C cable and charger.
- Do not operate with a damaged cord, plug, or if the appliance malfunctions.
- Avoid contact with moving parts.
- Do not use an extension cord; plug the charger directly into an electric outlet.
- Do not incinerate the appliance, as batteries can explode in a fire.
- Supervise children closely when the appliance is in use.
Blades: The blades are very sharp; use extreme caution. Never attempt to touch the blades with your fingers.
Assembly: Ensure the Power Base is screwed onto the Jar properly to prevent injury and leakage. Do not overtighten the Jar. Make sure the USB cover on the Power Base is closed before use.
During Operation:
- Do not put hands or other tools close to the blades while in use.
- Always wait until the blending cycle has completed before detaching the Jar.
- Release any pressure before pouring blended ingredients.
- If abnormal sounds, smells, or smoke occur, turn off immediately and contact Customer Service.
Charging: Do not attempt to use while charging.
Environment: Do not use when gasoline fumes or natural gas are in the air; use in a ventilated area.
Attachments: The use of attachments not recommended by the manufacturer (e.g., canning jars) may cause a risk of injury.
Cord Management: Do not let the cord hang over the edge of any table or counter.

Troubleshooting:

Machine does not work when Jar is screwed on: Ensure the cup is screwed on tightly enough.
Red light stays on during mixing: Indicates insufficient voltage; fully charge the Power Base.
Red light flashes, blades do not turn: The battery temperature in the Power Base is too hot. Power off the unit and let it cool before use.

For further assistance, contact Customer Service toll-free at 1-877-689-2838 or via email at help@nuwavenow.com (Mon-Fri 7:30am-4:30pm CST).

NuWave ON-THE-GO - Page 5

Related product manuals