Getting Started
Button Name
Function Use
POWER Turns the OxyPure
®
on and off. Press Power to turn the OxyPure
®
on and off.
AUTO
Allows you to run the OxyPure at the lowest fan
speed, raising it based on air quality.
Press AUTO and the Auto back light will turn on. There is no time limit on the Auto Mode. Press
AUTO again to deactivate Auto Mode.
ECO
MODE
Allows you to save energy by turning the OxyPure
fan off when it is not needed.
Press and hold AUTO for 1 second to activate Eco Mode. When the air quality is poor, the unit will
automatically run. When the air quality is good, the unit will turn off. Press AUTO and hold for 1
second to deactivate Eco Mode.
ULTIMATE
CLEAN
Automatically adjusts to the highest speed for
maximum cleaning based on the air quality.
Press ULTIMATE CLEAN to activate the Ultimate Clean Mode.
FLOW
ANGLE
Adjusts the louver angles. Press AIR FLOW ANGLE to adjust the louver angles from 30°, 60°, 90°.
FAN
SPEED
Adjusts the OxyPure’s fan speed.
There are 6 fan speed levels. Press FAN SPEED to adjust from Speed 1 (lowest) to Speed 6
(highest).
SLEEP
MODE
Turns off the control panel LED lights but keeps the
fan active.
Adjust the Fan Speed prior to activating Sleep Mode. Press and hold FAN SPEED for 2 seconds
to activate Sleep Mode. Press any button to deactivate it.
TIMER Helps limit the amount of time the OxyPure is on. The timer is adjustable from ½ hour to 1, 2, 4, 8, or 12 hours. To set the timer, press TIMER.
TURBO
Cleans the air using the highest speed for a set time
(½ hour, 1, or 2 hours).
Press TURBO once to run the OxyPure at the highest speed for ½ hour. Press TURBO twice for 1
hour. Press TURBO three times for 2 hours.
See the Owner’s Manual for details.
E1000
Air/Odor Quality - Detects particles as small as 2.5/1000mm
Particulate Matter (PM) with a diameter of 2.5 microns or less
0~5 5~10 10~20 20~30 30~50 Over 50
Fan Speeds
1 2 3 4 5 6
DirtyClean
Quick Start Guide
Refer to the Owner’s Manual for more details
Model No: 47251 / 47261
To Next Page
Need help?
General
