NXT Power INTEGRITY MAX L/T UPS Series

Questions and Answers

K
Keith EvansAug 6, 2025
How to fix Fault LED on NXT Power UPS?
- K
  Kayla JonesAug 6, 2025
  To address a lit Fault LED on your NXT Power UPS, start by identifying the specific error code displayed by the LEDs. If the error codes are Er05 or Er39, check the battery connections and measure the battery voltage to ensure they are charged. Recharge the batteries for about 8 hours if needed and test the UPS's DC backup by simulating a power outage. For an overload, disconnect some non-critical devices from the UPS. Inspect the cables for any short circuits due to damaged insulation and replace if necessary. For Er11, make sure that nothing is blocking the ventilation openings and that the cooling fans are running correctly. If the error code is Er14, verify that the fans are working. If the issue persists or the error code is different, further diagnosis is needed.
N
nmartinezAug 17, 2025
Why does my NXT Power UPS switch between battery and utility modes?
- N
  Natasha YoungAug 17, 2025
  If your NXT Power UPS switches to battery mode when a device is turned on, or if it alternates between battery and utility modes, avoid using a power strip. Instead, replace the wall receptacle or cord plug.
C
Christian BanksAug 27, 2025
What to do if NXT Power UPS makes strange noise or smell?
- A
  Angela CarpenterAug 27, 2025
  If your NXT Power UPS emits a strange noise or smell, immediately shut down the entire system and disconnect the UPS from the power source. Further assistance is needed.