NYMI BAND - User Manual

Instructions for extending the Nymi Band to fit your wrist comfortably.

Instructions for reducing the Nymi Band's length to fit your wrist.

Download the Nymi Companion app to your device for activating the Nymi Band daily.

Turn on Bluetooth on your device; a Nymi-compatible module is needed for Windows PCs.

Clasp the Nymi Band onto your wrist with the lights facing you.

The Nymi Band's lights pulse twice to indicate battery level after being worn.

The Nymi Band enters search mode. Ensure the correct light sequence appears.

Open the Nymi Companion app; it will guide you through Nymi Band setup.

Clasp the Nymi Band onto your wrist; activate it each time you wear it.

Lights pulse twice to show the battery level of the Nymi Band.

The Nymi Band automatically enters search mode.

Have the Nymi Companion app open on your device to find your Nymi Band.

Place a finger on the top sensor for your heart's electrocardiogram to be read.

The Nymi Band remains activated while worn and can interact with apps.

Open an Nymi-enabled app to authorize it for use with your Nymi Band.

Tap the top of your Nymi Band four times when prompted to put it in pairing mode.

The Nymi Band indicates it is searching for nearby applications.

The Nymi Band vibrates and shows one light when the battery is low.

A pulsing light indicates charging; check orientation if lights do not appear.

A full charge takes approximately two hours using a wall outlet or computer USB port.

Double-tap the Nymi Band when idle to check its status.

The Nymi Band has not been activated; activate it using the Nymi Companion.

The Nymi Band is activated and ready for use.

The Nymi Band is connected to an application and cannot connect to another.

The Nymi Band is water resistant, not waterproof. Do not shower or swim with it.

Avoid extreme temperatures, direct sunlight, and hot cars for Nymi Band.

Use only a clean, damp cloth for cleaning; avoid chemicals.

Check charger orientation and contact pins for proper charging.

Ensure band is worn, Bluetooth is on, and band is in search mode.

Clasping the band activates it; ensure it is charged and properly clasped.

Use a pin to briefly press the reset button to reboot without data loss.

Hold the reset button for 5 seconds to clear all settings and data.

Device compliance statements for FCC and Industry Canada regulations.

Covers handling, repair, battery, water, charging, and sizing safety guidelines.

Information on proper disposal and recycling of the Nymi Band.