Need help?Do you have a question about the NZXT KRAKEN X73 RGB and is the answer not in the manual?
General| Type | All-in-one liquid cooler |
|---|---|
| Fan diameter | 120 mm |
| Fan speed (max) | 1500 RPM |
| Fan speed (min) | 500 RPM |
| Maximum airflow | 52.44 cfm |
| Suitable location | Processor |
| Maximum air pressure | 1.35 mmH2O |
| Minimum air pressure | 0.15 mmH2O |
| Fan noise level (max) | 33 dB |
| Fan noise level (min) | 22 dB |
| Pump motor speed (max) | 2800 RPM |
| Pump motor speed (min) | 800 RPM |
| Minimum airflow (imperial) | 17.48 cfm |
| Supported processor sockets | LGA 1150 (Socket H3), LGA 1151 (Socket H4), LGA 1155 (Socket H2), LGA 1156 (Socket H), LGA 1200 (Socket H5), LGA 1366 (Socket B), LGA 2011-v3 (Socket R), LGA 2066, Socket AM4, Socket TR4, Socket sTRX4 |
| Pulse-width modulation (PWM) support | Yes |
| Pump current | 300 mA |
| Pump voltage | 12 V |
| Fan connector | 4-pin |
| Product color | White |
| Number of fans | 3 fan(s) |
| Radiator material | Aluminum |
| Illumination color | Multi |
| Tube material | Rubber |
| Country of origin | Taiwan |
| Number of screws | 28 |
| Harmonized System (HS) code | 84733080 |
Weight and Dimensions| Tube length | 400 mm |
|---|---|
| Radiator depth | 394 mm |
| Radiator width | 121 mm |
| Radiator height | 27 mm |
Prepares the backplate and installs standoffs for Intel LGA 1200/115X/1366 sockets.
Prepares the backplate and installs standoffs for Intel LGA 2011/2066 sockets.
Prepares the retention bracket and installs standoffs for AMD AM4 sockets.
Details how to orient the pump cap for optimal tube positioning.
Attaches the pump with the retention bracket onto the CPU for Intel/AMD AM4.
Mounts the pump for AMD TR4 sockets, detailing screw alignment and tightening sequence.
Explains direct and indirect mounting methods for the radiator and fans.
Guides on connecting fans using a splitter to the motherboard or fan controller.
Connects the pump tachometer signal to the motherboard's CPU_FAN or AIO_PUMP header.
Connects the SATA power cable from the power supply to the cooler's power cable set.
Connects the Micro-USB cable from the pump to an internal USB 2.0 header.
Connects NZXT RGB devices to the breakout cable's RGB LED connector.
Details connecting the fan connection cable to Aer RGB 2 fans and daisy-chaining them.
Outlines the terms, conditions, and duration of the product's warranty.
Provides contact information and methods for obtaining technical support and service.
Contains FCC compliance, operating temperature limits, and safety warnings.
To Next Page
