49
6.2 Start-up and shut-down
DANGER!
Check correct functioning of the maintained action levers and double safety command before
using the machine. See „CABLE ADJUSTMENT” to make adjustments. It is forbidden to use the
machine in case of malfunction of the controls.
CAUTION!
Check the motor oil level before starting the machine.
INFORMATION!
If the engine is „cold”, operate the starter on the carburettor (depending on the motor version).
See the specific manual.
To start:
Once the engine has started, move the lever in figure to the intermediate position.
To switch off:
6.3 Machine commands
The forward, reverse and tool engagement commands are maintained and activated by double
control.
FORWARD MOVEMENT:
REVERSE MOVEMENT (if available):
TOOL ENGAGEMENT:
6.4 Handlebar adjustment
To Next Page
Loading...