30
DC Power Supply Auto
Use only the power supplies provided with this device.
The DC power cord allows you to power your Oxlife Independence from
your vehicle's (car, boat, RV) 12/15 volt DC outlet, (cigarette lighter) in all
settings. Use the DC outlet closest to the battery. Use no other DC outlets in
the vehicle. If your vehicles DC power drops to 11.6 volts or below, the
device will revert to battery power. A 15 amp outlet at 12 volts is
recommended for use with the device.
The external power icon will be displayed on the control panel.
Recommendations for Use:
ALWAYS have the vehicle's engine running before plugging in your Oxlife
Independence. With the engine running, plug in and turn on your device.
When operating the Oxlife Independence in your vehicle, ensure that the
device is securely stowed and will not get damaged during transport.
Ensure that air inlet and exhaust ports are not blocked.
Batteries will not charge at any setting if the engine is not running.
DC power is not sufficient to charge the batteries at all settings. Charging
will NOT occur at settings higher than Continuous 2.0 or Pulse 4.0.
The device may “rev” more while operating on DC power. This is normal
operation while connected to DC power and not cause for any concern.
DO NOT leave the device plugged into the vehicle when the engine is not
running.
DO NOT use the Oxlife Independence with any power splitting devices.
To Next Page
Loading...
Need help?
General
