O2 XM - Checking the Package Contents; Installing the SIM Card; Battery Management; The Battery

Notes
3
Checking the package
When you open the sales package you will  nd the
phone itself, the battery, the charger, the stereo
headset and this user guide. Depending of your place of
purchase, various accessories may be included. Contact
your retailer if any of the above items are missing.
Installing the SIM card
To connect to your network operator your phone must
have a SIM card installed. The SIM slot is located under
the battery and the card is most likely installed by your
retailer. If not, or if you need to replace the SIM:
[E22_simoff.jpg]
>
Switch off the phone [on_off.bmp] and
remove
charger if connected
>
Release the battery and remove it to access the SIM
slot
>
Slip the SIM card under the metal bracket, gold-
plated side down and with the cut corner of the card
matching the slot pro le.
Never use force.
Avoid
touching the gold-plated side of the SIM
>
Reinstall the battery
The battery
Your phone comes with a high-performance
rechargeable battery. The battery must be fully
charged before you use your phone to ensure correct
reading of the power indicator.
Use only the charger
supplied with the phone.
To install the battery, align the pins at the bottom with
the guides in the cover and click in place. To remove
the battery, press the button on the back of the phone
and lift off. The battery must be installed on the phone
prior to charging.
[E22_battoff.jpg]
Charging the battery
>
Connect the charger to the plug at the base of the
phone
>
Connect charger to mains
<
a pop-up message indicates charging in progress
< when  nished, a new pop-up indicates charging
completed
> Remove charger from mains by pulling the charger
itself (do not pull cord)
Note:
Recharge battery when alerted of low power. If
battery is completely discharged, you will experience
a few minutes of display inactivity before recharging
initiates. In extreme cases, the phone may pre-charge
for up to 30 minutes before the display animation
starts. Charging will be indicated by a red light in the
LED. Also read the paragraph “The multimedia phone
and power management”
Connecting to the network
Your SIM card is protected by a PIN code to prevent
misuse. This code is four digits long and is printed in
the information material that came with your card.
This information also contains a code (PUK) you must
enter if you accidentally lock the SIM card.
>
Turn on the phone by pressing the [on_off.bmp] key
for 2 seconds
< a tune is heard and the display becomes active. You
are prompted to enter the PIN code