Page 11
Post Installation Instructions
With the components installed and wired, please carry out this simple test to ensure that
the Oaks Smart Access Control System was installed correctly and is fully functional.
To ensure that there was wiring was done correctly, please press the exit button to see if
the single door magnetic lock releases for a few seconds.
If the test is failed, please reexamine the installation and wiring of the Oaks Smart Access
Control System.
If the test is successful, please Install and power on the Rently Keyless Smart Home
Hub. The hub will automatically connect to the Oaks Smart Access Control system when it
is powered on.
Once the light on the back of the hub is a solid blue, you are all set!
To Next Page
Loading...