How to fix no water outlet from the pond inlet with my Oase Water Pump?
If there is no water outlet from the pond inlet, it could be due to the pump power supply not being connected. Connect the pump power supply. Alternatively, the pond inlet may be blocked, so clean the pond inlet.
Why is the Oase Water Pump not clearing the water?
The Oase Water Pump may not be clearing the water due to several reasons: * The unit may have been in operation for only a short time. The complete biological cleaning effect is only achieved after several weeks. * The pump capacity might be inadequate, so readjust it. * The water may be extremely soiled, so remove algae and leaves from the pond and perform a partial water change. * There might be an excessive fish and animal population. A guide value is approximately 60 cm fish length in 1 m3 pond water. * The foam filters could be soiled, so clean them.
What to do if the maintenance lamp flashes on my Oase Water Pump?
If the maintenance lamp is flashing on your Oase Water Pump, it indicates that either the Screenex screen or the foam filters are soiled. Clean the Screenex screen or clean the foam filters to resolve this issue.
General| Brand | Oase |
|---|---|
| Model | Biotec 18 |
| Category | Water Filtration Systems |
| Language | English |
To Next Page