OBDLink LX User Manual

OBD
HOSTPOWER
BT
OBD
H
OST
P
OWER
BT
'Connect'
button
Android Quick Start Guide
OBDLink
®
LX Bluetooth
Android
Scan the QR code or visit the URL from your Android
device to download the OBDLink app:
obdlink.com/app
Download & install OBDLink app
The OBD port is usually found on the driver’s side,
under the dash.
‘POWER’ LED will turn ON, and the ‘BT’ LED will
start ashing slowly.
You must complete steps 7, 8, and
9 within 2 minutes. If you need
more time, press the button again.
Attention!
The ‘BT’ LED will switch to a fast blink.
Tap ‘Scan’ if OBDLink LX does not show in ‘Available
devices’.
– LEDs are o? Check vehicle for blown fuses.
[instructions continue on reverse]
Plug OBDLink LX into the OBD port
Turn ignition to Key On, Engine O
position
Open ‘Settings’ app, and enable
‘Bluetooth’
Press and release the ‘Connect’ button
on OBDLink LX
Tap ‘OBDLink LX’ to pair the deviceTap ‘Bluetooth - Pair with a device’
Wait for OBDLink LX to appear on the
‘Available devices’ list
1
2
3
4
6
85
7
Vehicles with push button start: press the button without
stepping on the brake pedal.

OBDLink LX Specifications

General

Compatibility	OBD-II compliant vehicles
Operating Voltage	8-18V DC
Connectivity	Bluetooth
Warranty	3 years
Protocols	J1850 PWM, J1850 VPW, ISO9141-2, ISO14230-4 (KWP2000), ISO15765-4 (CAN)
Operating Temperature	-4° to 131° F (-20° to 55° C)

Summary

OBDLink LX Bluetooth Android Quick Start Guide

Download and Install OBDLink App

Scan QR code or visit URL to download the OBDLink app on your Android device.

Connect OBDLink LX to OBD Port

Plug the OBDLink LX into the vehicle's OBD port, typically found under the dash.

Prepare Vehicle and OBDLink LX

Turn ignition to Key On, Engine Off. Check LED status. For push-button start, press button without brake.

Enable Bluetooth and Pair Device

Enable Bluetooth on your device, then pair with OBDLink LX via its 'Connect' button.

Configure OBDLink App

Launch the OBDLink app, select Bluetooth, and choose OBDLink LX from the device list.