11. Stand the unit up on its feet and slide the fabric out of harm’s way at the top.
Apply cement to two (2) elbows on the crossbar and two (2) appropriate tubes.
Working quickly, align the elbows with the two (2) tubes and pull down until
they bottom out.
Hold for 15 seconds. Repeat with the other two (2) crossbars.
NEXT:
12. Lay the unit on a large table or on the oor, propped up on the bottom end, by
way of a convenient means, to tighten up the lacing.
Untie the end with the slip knot. At the other side of the lacing, pull on the
lacing, grommet by grommet, and pull the fabric to about 1” from the bottom
crossbar.
Wrap the excess cord around the crossbar and tie it o with two (2) half hitches
or a knot of your choice that won’t come loose.
Tighten up the other two (2) panels.
Assembly Instructions
© Oberon
TM
| All rights reserved. Page 7 of 10
Arc Curtain Cube
To Next Page
Loading...
Need help?
General
