OBH Nordica OptiGrill User Manual (English)

Questions and Answers:

M
Melinda GuzmanJul 28, 2025
Why does my OBH Nordica OptiGrill Grill switch to manual mode?
- D
  donnarobinsonJul 29, 2025
  If your OBH Nordica Grill switches to manual mode when starting a cooking cycle, it might be because you started cooking without preheating. You can either allow the cooking to continue, monitoring it in manual mode (white LED), or stop the appliance, remove the food, close it properly, reprogram, and wait for preheating to finish. If this continues, it may indicate an appliance failure, and you should contact your local Tefal Customer Service.
M
Megan RodriguezAug 4, 2025
What to do if the indicator stays on purple on OBH Nordica OptiGrill Grill?
- J
  Jon PerezAug 4, 2025
  If the indicator light on your OBH Nordica Grill stays purple after placing food, ensure you fully open the grill before placing the food and then close it completely. Also, the grill might not be sensing the food if it's too thin (less than 4mm). Press the button to confirm the start of cooking.
K
Krista RichardsonAug 9, 2025
Why does my OBH Nordica Grill stop during cooking?
- C
  Crystal JonesAug 10, 2025
  If your OBH Nordica Grill stops during pre-heating or cooking, it could be because it was left open too long. Disconnect the appliance from the mains, wait 2-3 minutes, and restart the process. Ensure you briefly open and close the appliance during use for optimal results. If the issue persists, contact your local Tefal Customer Service.
D
Dawn BrooksAug 16, 2025
What does flashing white indicator mean on OBH Nordica OptiGrill Grill?
- D
  diazwalterAug 16, 2025
  If you see a flashing white indicator light and the button is flashing on your OBH Nordica Grill, try disconnecting and reconnecting the appliance, then immediately restart a preheat cycle. This issue can also happen if the appliance is stored or used in a room that is too cold. If the problem persists, contact your Customer Service.
B
brianturnerAug 21, 2025
What to do if indicator flashing after placing food on OBH Nordica Grill?
- J
  Jacob PhillipsAug 21, 2025
  If the indicator is flashing after placing food on the cooking plates of your OBH Nordica Grill, the grill might not be sensing the food, possibly because the meat is too thin. You must confirm the start of the cooking by pressing the button.

OBH Nordica OptiGrill Specifications

General

Automatic sensor cooking	Yes
Removable plates	Yes
Dishwasher safe	Yes
Drip tray	Yes
Type	Contact grill
Cooking Surface Material	Non-stick
Cooking programs	6
Features	Adjustable thermostat
Temperature control	Adjustable