POWER CONNECTIONS
The Obsidian Control Systems NX4 is rated 100-240V 50/60Hz and accepts AC mains power
over a range of 90-264V 50/60Hz. Do not connect it to power outside this range. Damage
resulting from incorrect connection is not covered under warranty.
North America: A cable with a NEMA 15-5P plug is provided for use with the NX4 in the USA and Canada.
This approved cable must be used in North America.
Rest of the world: The provided True1 cable is not fitted with a country-specific plug. Install only a plug
that meets local and or national electrical codes and is suitable for the country’s specific requirements.
WARNING! Single fuse in the Line side. The NX4 is protected by a single 2A slow blow mains
fuse in a fuse holder on the inside of the controller on the PSU cover.
A 3-prong grounded-type (earthed type) plug must be installed following the plug manufacturer’s
instructions. The table below shows some possible pin identification schemes; if the pins are not clearly
identified, or if you have any doubts about proper installation, consult a qualified electrician.
Wire Color (Standard EU Code)
To apply power to the product:
1. Set the power switch to the OFF position.
2. Insert the provided power cable into the True1 connector of the power supply unit and connect the
cable to a properly protected and grounded outlet.
3. Turn the console on by toggling the power switch to ON.
To Next Page
Loading...