3. Alarm Volume: You can set the alarm sound level.
Remark：The NAP Alarm will only with beeping sound.
4. Alarm Sounds setting：Beep/Melody/Internet Radio
5. When the Alarm comes on, press any key except “Power” button, you
can enter the “Snooze” mode. You can press “Power” button to cancel
the alarm sounds again 5 minutes later.
Remark: You can select any internet radio station as Alarm tone
from the favorite station. When the internet station doesn't work in 1
minute, it will auto set into beeping sound.
Timer
The Timer can be set for 99:59. Use “ ◄ ” “ ► ” or “ ▲ ” “ ▼ ” to adjust the
time you desire. Press <OK> to start the timer. Whenever you want to
pause, press <OK> and to resume it, press it again.
To cancel the timer, press and hold the <OK> button until the 00:00
appears, then press the <OK> to exit.
Language
There are 17 Languages available, such as English, German, French,
Norwegian, Italiano, Svenska, Dansk and others.
Dimmer
You can adjust the backlight of the LCD with below settings:
1. Power Saving You can set the backlight dim down level when there is no
operation after 15 seconds.
2. Turn on
The backlight will not dim down even there is no operation if this option is
selected. You can adjust the backlight level you want.
Display
You can choose the display show in color or Monochrome.
Power Management
This function is to allow the radio to go to Standby if there is no internet
signal received in order to save power. The default setting is 30 minutes,
the radio will go into Standby after 30 minutes when the radio does not
receive any internet signal. Other time frame for 5 minutes and 15 minutes
are available.
Sleep Timer
You can set the timer to put the radio on standby after certain time elapsed,
from 15 minutes to 180 minutes with the step of every 15 minute.
You also can do the setting with the “Sleep” button from remote control,
when you press “Sleep”, then you can see the sleep timer on the top right
corner of the display.
16
To Next Page
Loading...