Connecting to your WiFi Network
The following screen will appear. You can choose <Yes> to proceed to
search for the available WiFi network. If your router has the WPS function,
you can select the <Yes (WPS)> to proceed.
It will then start scanning the network. After the search is done, it will
display a list of the available router.
Choose your router from the list, enter the WEP(Wired Equivalent Privacy)
or WPA(Wi-Fi Protected Access) code. If your network is not configured to
be with the WEP or a WPA code, the unit will connect to the router
automatically.
Note: The encryption code would have been set up by the person who
set up and configured your network.
Please refer to the “Remote control character list” for you to enter the
passwords. Press the
“ ► ” button to go to the next entry, press “ ◄” button to make correction.
The radio will start connecting to the network.
After the router is connected successfully, it will display the menu screen:
You can now start enjoying the internet radio.
01:01
Would you like to
configure Network now?
Yes(WPS) NOYes
Linksys
Homeaudio
Demo
01:44
MOVE INPUT: OK
Enter
Password
1/1
16:23
08:58
Internet Radio
5
To Next Page
Loading...