Ocean Signal EPIRB1 User Manual

EPIRB1 User Manual
912S-01365 v01.22 3 01/06/23
IN CASE OF EMERGENCY
USE ONLY IN SITUATIONS OF
GRAVE OR IMMINENT DANGER
1. Press on the release tab
2. Pull the EPIRB from the bracket
3. Pull the antenna out from the body to its full extent*
by pulling on the red cap
4. Remove break off tab
5. Lift the flap up
6. Press the ON key for one second to activate the
beacon
The green led will flash to indicate activation
Release the ON key
The strobe light will start flashing to indicate it is
activated
Remove the lanyard cover
Holding the free end of the lanyard, throw the EPIRB
into the water
* Pull the antenna out until firm resistance is felt.
The antenna will extend to 25.5cm.
Note: Refer to section 4.2 for deactivation instructions
1
2
3
4
5
6

Ocean Signal EPIRB1 Specifications

General

Brand	Ocean Signal
Model	EPIRB1
Category	Security System
Language	English