EPIRB3 Pro USER MANUAL
12 912S-03968 - 01.02 14/11/2022
4.2 Mounting Dimensions
4.3 Fitting the Auto Release Housing
Using the dimensions shown, use four of the No10 x 1” screws supplied to secure the Auto
Release Housing to the chosen structure using the holes marked ‘O’ on the diagram . For
mounting surfaces constructed of a material unsuitable for these screws use suitable
fixings (not supplied).
Fixing holes ‘E’ are provided to match the Ocean Signal E100/E100G if this product is being
used to replace these older models.
Retro-fit Adapter Bracket
To Next Page
Loading...
Need help?
General
