Ocean Signal rescueME Series User Manual

EPIRB1 USER MANUAL
3 Version 00.03 25/07/2014
IN CASE OF EMERGENCY
USE ONLY IN SITUATIONS OF GRAVE
OR IMMINENT DANGER
• REMOVE THE EPIRB FROM THE BRACKET
• PULL THE ANTENNA OUT FROM THE BODY TO ITS
FULL EXTENT
*
USING THE RED TAB.
• REMOVE BREAK OFF TAB
• LIFT THE FLAP UP
• PRESS THE ON KEY (5) FOR ONE SECOND TO
ACTIVATE THE BEACON.
• THE GREEN LED WILL FLASH TO INDICATE
ACTIVATION
• RELEASE THE ON KEY.
• THE STROBE LIGHT WILL START FLASHING TO INDICATE IT IS
ACTIVATED
• REMOVE THE ,LANYARD COVER (6)
• HOLDING THE FREE END OF THE LANYARD, THROW THE EPIRB
INTO THE WATER.
* Pull the antenna out until firm resistance is felt. The antenna will extend to 25.5cm.
Refer to section 3.2 for deactivation instructions.
1
2
3
4
5
6
PE TC "Omega"
Report 14/171 - Issue 3
Page 238 of 337

Ocean Signal rescueME Series Specifications

General

GPS	Yes
Activation Method	Manual
Type	Personal Locator Beacon (PLB)
Frequency	406 MHz
Operating Temperature	-20°C to +55°C
Certifications	Cospas-Sarsat, FCC, MED
Waterproof	IP68 (15m depth)