Need help?Do you have a question about the OCEANAIRE 2OAC Series and is the answer not in the manual?
Explains the model numbering system and its components.
Outlines the basic warranty coverage for OceanAire products.
Details the cabinet material, finish, insulation, handles, and casters.
Describes the features and functions of the unit's electronic controller.
Explains automatic and manual fan speed adjustments available on the controller.
Covers condensate collection methods, tanks, and automatic pump features.
Describes the washable filters and their location for air intake and condenser.
Details the function and location of the compressor protection safety switch.
Information on standard power cords and LCDI safety features for models.
Describes using the unit for targeted cooling in open environments.
Explains how to use the unit for cooling specific open areas with ducted exhaust.
Details converting the unit for enclosed space cooling with ducting.
Information on service cord length, plug configurations, and receptacle types.
Warnings regarding LCDI use and power supply cord replacement.
Important notice regarding three-phase models and phase monitors.
Instructions for adjusting the condensate tank's high water level switch.
Accessory for directing condenser air above a drop ceiling.
Kit to direct conditioned air to specific target areas for focused cooling.
Accessory for automatic condensate removal to a drain.
Accessory to duct air to the condenser inlet, reducing noise.
Accessory to duct air to the evaporator inlet, reducing noise.
Adapter to convert evaporator discharge to different round duct sizes.
Steps for inspecting the unit upon delivery for any damage.
Instructions for checking the unit for damage before proceeding with installation.
Guidance on checking nameplate for proper voltage and amperage.
Recommendation for using time delay fuses or circuit breakers.
Critical warning that improper voltage voids the unit's warranty.
Steps for powering up the unit and verifying proper operation.
Details on accessing and adjusting various program settings (P1-P16).
Clarification that listed parameters are factory settings, not defaults.
Explains common error codes and their meanings for troubleshooting.
Procedure to check the total compressor run time hours displayed on the unit.
Step-by-step guide for replacing evaporator and condenser fan motors.
Instructions for removing and installing the electronic controller display.
Steps for accessing and replacing the unit's power module.
Procedure for replacing the condensate pump on applicable units.
Guide for replacing the high pressure safety switch.
Identifies causes and remedies for units that fail to power on.
Addresses issues where fans operate but the compressor or condenser fan does not.
Information on blower motor lubrication and maintenance.
Recommendations for inspecting and cleaning the unit's air filters.
Steps for servicing and cleaning the condensate pump.
General advice on unit longevity and when to use qualified technicians.
Explains LED indicators and function for ICM401/ICM402 series monitors.
Details LED indicators and operation for SSAC series three-phase monitors.
Provides contact information for technical support and service parts.
General| Refrigerant | R410A |
|---|---|
| Type | Air Conditioner |
| Seasonal Energy Efficiency Ratio (SEER) | 16 |
| Power Supply | 220-240V, 50Hz |
| Weight (Indoor Unit) | 9 kg |
To Next Page
