RevoDrive 350 User Guide
4 © 2015 OCZ Storage Solutions, Inc. - A Toshiba Group Company
Installation as a storage device in Windows
To use the RevoDrive 350 as a storage device in Windows:
1 Install the hardware; see page 3.
2 Install or update the driver; see page 2.
3 Format the RevoDrive 350 as storage.
The following instructions are a general guideline for installation in Windows 7; it is assumed that you
have access to the system user manual for full instructions. Installing in other Microsoft operating
systems is similar; see your system user manual.
Format the RevoDrive 350 as storage
Before starting, ensure that you have followed the instructions in Install or update the driver on
page 2.
1 Switch on and start up the computer.
2 Click the Windows Start button in the taskbar, right-click Computer and select Manage. The
Computer Management window is shown.
3 In the left pane, expand Storage then click Disk Management. Available disks are listed.
4 Select the RevoDrive 350.
If the RevoDrive 350 is already initialized, go to step 5.
If you have not previously initialized it, wait for the lnitialize Disk window to load and click OK to
initialize it.
5 To format the drive, right click the graphical bar representing unallocated disks and select New
Simple Volume.
6 Follow the onscreen instructions to finish formatting the drive.
Your RevoDrive 350 is now ready to use for storage.
To Next Page
