connector from the fuel pump.
Install a temporary connector to the fuel
pump connector. Apply 12V to this test
harness.
CAUTION
Running the fuel pump a few minutes with
reverse polarity can damage the pump.
If pump does not run, replace a new pump.
Other wise, check fuse and if good, probe
terminals of fuel pump connector on
vehicle harness or its connector, Repair or
replace appropriate part.
Fuel pump removal
Remove fuel pump outlet hose and harness.
Remove fuel pump retaining screws.
Gently push pump up.
While pulling out the fuel pump, pay
attention to fuel sensor float arm. Float arm
can get stuck and bend which can reduce
the fuel sensor capabilities.
COOLING SYSTEM
Recommended Engine Coolant
NOTICE: Always use ethylene-glycol
antifreeze containing corrosion inhibitors
specifically, formulated for internal
combustion aluminum engines.
Verifying the Engine Coolant Level
Check coolant level with engine cold.
heck coolant level with engine cold.
Never add coolant in cooling' system
when engine is hot.
TYPICAL
1. Radiator cap
2. Engine coolant reservoir
1. Remove the radiator cap by applying.
pressure and turning it counterclockwise.
Then drain the antifreeze from the engine.
Complete the radiator filling.
Check the level in the coolant reservoir and
refill if necessary
Run engine at idle with the radiator cap off.
Slowly add coolant if necessary. At this
point, wait until engine reaches normal
operating temperature.
To Next Page
Loading...
