3. Crank the engine over, 1 or 2 seconds
maximum, to lubricate cylinders.
4. Reinstall the spark plugs.
NOTE: Do not run engine during storage
period.
5. Block muffler outlet, engine air inlet and
CVT outleth.
NOTICE: To avoid causing damage to
vehicle, use memory aid to make sure rags
are removed from their installed location.
CVT Protection
Remove drive belt. Refer to ENGINE, CVT
AND GEARBOX.
Close CVT cover. Block CVT outlet with a
rag.
NOTE: To reach the CVT outlet, detach it
from exhaust heat shield.
ELECTRICAL SYSTEM
Battery Removal
Remove the battery.
Charge and store battery.
CHASSIS
Lubrication
Lubricate front and rear suspension and
rear sway bar.
Tire Pressure
Inflate tires to the recommended pressure.
Vehicle Cleaning
Wash and dry the vehicle.
NOTICE: Never use a high pressure washer
to clean the vehicle. USE LOW PRESSURE
ONLY (like a garden hose). The high
pressure can cause electrical or mechanical
damages.
Remove any dirt or rust.
NOTICE: It is necessary to use flannel cloths
on plastic parts to avoid damaging
surfaces."Never clean plastic parts with
strong detergent, degreasing agent, paint
thinner, acetone, products containing
chlorine, etc.
Vehicle Protection
Protect the vehicle with a cover to prevent
dust accumulation during storage.
NOTICE: The vehicle has to be stored in a
cool and dry place and covered with an
opaque tarpaulin. This will prevent sun rays
and grime from affecting plastic
components and vehicle finish.
PRESEASON PREPARATION
Proper vehicle preparation is required after
a storage period.
Any worn, broken or damaged parts found
must be replaced.
Remove rags that were installed for storage:
engine air inlet hose, CVT outlet hose and
muffler. Clean drive and driven pulleys to
remove storage protective lubricant, then
reinstall drive belt. Refer to CONTINUOUSLY
VARIABLE TRANSMISSION (CVT).
Remove parts required to allow inspection
of entire engine air inlet system. Check for
animal nests and other foreign material.
Reinstall removed parts.
Drain fuel tank and fill with fresh fuel if a
fuel stabilizer was not used for storage.
Reinstall battery. Refer to CHARGING
SYSTEM subsection.
Inflate tires to the recommended pressure.
NOTE: Perform any due maintenance items
as per the MAINTENANCE SCHEDULE.
Test drive vehicle.
To Next Page
Loading...
