Engine Mount Installation
The installation is the reverse of the removal
procedure.
TOW HITCH
Inspecting the Tow Hitch
Ensure tow hitch receptacle module is
solidly mounted.
Inspect hitch for cracks and other damages.
Repair or replace as necessary.
PASSENGER HANDHOLDS
Passenger Handhold Condition
Check if the passenger handholds are fixed
firmly, not bent or otherwise damaged.
Replace if necessary.
STORAGE PROCEDURE
GENERAL
If the UTV is not used or is to be stored for
an extended period of time, more than 4
months, be sure to perform the storage
procedures described below.
Where applicable, refer to the appropriate
subsections in this manual for the required
tasks outlined in these procedures.
PROCEDURES
NOTE: To facilitate the inspection and
ensure adequate lubrication of components,
it is recommended to clean the entire
vehicle. Refer to VEHICLE CLEANING in this
subsection.
FUEL SYSTEM
Fuel System Protection
With the new fuel additives, it is critical to
use the FUEL STABILIZER to prevent fuel
deterioration and fuel system gumming.
Follow the manufacturer's instructions for
proper use.
NOTICE: Fuel stabilizer should be added
prior to engine lubrication to ensure fuel
system components protection against
varnish deposits.
Pour fuel stabilizer in fuel tank. Fill up fuel
tank.
ENGINE
Engine Internal Lubrication
Engine internal parts must be lubricated to
protect them from rust formation during
the storage period.
Proceed as follows:
1. Remove spark plugs.
2. Spray storage oil into each cylinder.
NOTE: Use the storage oil as per country
availability.
To Next Page
Loading...
