Rear
Inspect the suspension arm and for
damage or distortion. If any damages or
distortion are found, replace the
suspension arm with a new one.
Move suspension arm from side to
side. There should be no noticeable loose.
Replace bushing if necessary.
Move suspension arm up and down.
There should be no noticeable loose.
Replace bushing if necessary.
REASSEMBLY
Pay attention to the following points.
1.Install the washers and tighten the
knuckle nuts to the specified torque. Replace the removed cotter pins with new cotter pins.
2.Replace the removed cotter pins with new
cotter pins.
Inspecting the Suspension Arm
Check suspension arm for:
-Cracks
-Pitting
-Bending
-Distortion
Check suspension arm for abnormal play:
- Side to side
-Up and down
If any play is detected, inspect:
- Bushings
- Cushions
-Wear plates
Check ball joint for:
-Damage
- Pitting
- Play
Check ball joint bellows for:
- Damage
-Cracks
Knuckle
Inspect the knuckle for damage. If any
damages are found, replace the knuckle
with a new one.
Check bearing and seal for damage or wear,
If any damages or wear are found, replace a
new one.
Rotate the inner race by hand to inspect for
abnormal noise and smooth rotation.
To Next Page
Loading...
