Thank you for purchasing this OdorStop product. Please read the instructions carefully and follow all
warnings. All OdorStop products are manufactured to be simple to use and provide years of worry free
service when the recommendations in this manual are followed. Please call OdorStop at 1(888) 956-7468
with any questions or concerns.
WARNINGS
• Do not move or carry the blower while it is operating. When the blower is operating, the powerful
airow can cause unpredictable movement.
• NEVER allow children to play with or around blower.
• Do not alter or modify your blower in any way. Use only replacement parts authorized by OdorStop.
Modications or use of unauthorized parts could create a hazard and will void your warranty.
• Store blower in a clean, dry environment. Do not store outdoors or allow water inside the unit’s motor.
If the motor becomes wet, allow it to thoroughly dry before use.
• Blower should never be operated near water as it will create a risk of serious injury from electrical
shock.
• Handle unit with care to avoid causing damage or injury.
• Blower should always be operated on a at surface. Do not operate where unit could fall, or on
slippery surfaces, as this could increase the chance of injury, re, or electrical shock.
• Keep all materials, liquids, and gases from being drawn into blower and never operate unit without
factory installed safety screens in place.
• Do not use blower near combustible gas, or for circulating hot air as unit could melt and cause a re or
electrical hazard.
• Do not take blower apart or repair it unless you are qualied to do so. Never repair or service unit while
blower is plugged in.
• Make sure the air intake and outlet are free from all materials and away from obstructions, as any
restrictions may cause the blower to overheat and cause a shock or re hazard.
OPERATION
This OS1000/OS2800 high velocity air mover is designed for oor drying, water damage restoration,
and ventilation.
1) Place the blower on a level and stable surface.
2) Plug the blower into a grounded outlet with the correct voltage and amperage. For maximum
protection against electrical shock, ALWAYS use a circuit that is protected by a ground fault circuit
interrupter. If you are unsure about the outlet, check with a qualied electrician or service person.
3) Turn the switch to desired speed setting and check that the blower operates properly before
letting it run.
To Next Page
Loading...