3
Operating Instructions and Parts Manual 24359
DIGITAL BATTERY ANALYZER
4/18
2018 OEMTOOLS
™
clothing and keep hands and fingers away from
moving parts. Keep hoses and tools clear of
moving parts. Always stay clear of moving engine
parts. Hoses and tools can be thrown through
the air if not kept clear of moving engine parts.
The unexpected movement of a vehicle can injure
or kill. When working on vehicles always set the
parking brake or block the wheels.
25. Avoid accidental fire and/or explosion. Do not
smoke near engine fuel and battery components.
26. The warnings, precautions, and instructions
discussed in this manual cannot cover all possible
conditions and situations that may occur. The
operator must understand that common sense
and caution are factors which cannot be built into
this product, but must be supplied by the operator.
27. For safety purposes and the prevention of
damage to expensive components it is advised
that the user have an understanding of basic
automotive repair and a working knowledge of
automotive systems.
28. We believe the information contained herein to be
reliable. However, general technical information
is given by us without charge and the user shall
employ such information at his own discretion
and risk. We assume no responsibility for results
or damages incurred from the use of such
information in whole or in part. Always refer to
specific instructions and technical information
supplied by vehicle manufacturer.
29. The manufacturer declines any and all
responsibility for damage to vehicles or
components if said damage is the result of
unskillful handling by the operator or of failure
to observe the basic safety rules set forth in the
instruction manual.
DISPOSAL
At the end of the useful life of the Digital Battery
Analyzer, dispose of the components according to all
state, federal, and local regulations.
PURPOSE
A safe, fast, simple, and portable battery, starting and
charging system analyzer.
Battery CCA:
200-1200
Voltage Testing Range:
7-15VDC
Maximum Power
Consumption:
.5W
Operating Temperature:
14 – 122 Degrees Fahrenheit
Testing Standards:
SAE, DIN, EN, IEC, CA, JIS
Tests:
Internal Resistance
PRODUCT SPECIFICATIONS
To Next Page
Loading...