UNPACKING
After unpacking unit, inspect carefully for any damage that
may have occurred during transit. Check for loose, missing,
or damaged parts. If any damage is observed, a shipping
damage claim must be filed with carrier. DO NOT use
the OEMTOOLS
®
Cordless Angle Grinder if broken, bent,
cracked or damaged parts (including labels) are noted. Any
Cordless Angle Grinder that appears damaged in any way,
operates abnormally or is missing parts should be removed
from service immediately. If you suspect that the Cordless
Angle Grinder was subjected to shock load (a load that
was dropped suddenly, unexpectedly, etc.) immediately
discontinue use until it has been checked by a factory
authorized service center.
*Voltage is measured without workload. Maximum initial
battery voltage after charging. Nominal voltage is 18 Volts.
Please read and save these instructions. Read through this owner’s manual carefully before using product. Protect yourself and
others by observing all safety information, warnings, and cautions. Failure to comply with instructions could result in personal
injury and/or damage to product or property. Please retain instructions for future reference.
The following safety information is provided as a guideline to help you operate your Cordless Angle Grinder under the safest
possible conditions. Any tool or piece of equipment can be potentially dangerous to use when safety or safe handling instructions
are not known or not followed. The following safety instructions are to provide the user with the information necessary for safe
use and operation. Please read and retain these instructions for the continued safe use of your service system. Failure to
follow instructions listed below may result in serious injury. In addition, make certain that anyone who uses the equipment
understands and follows these safety instructions as well.
Operating Instructions and Parts Manual 24492
FOR CUSTOMER SERVICE
Technical Question?
CALL 1-866-458-2472
customerservice@oem-tools.com
20V MAX* LI-ION CORDLESS
ANGLE GRINDER
Thank you very much for choosing an OEMTOOLS
®
Product!
For future reference, please register your new tool at www.oem-tools.com and complete the owner’s record below:
Model: _______________ Purchase Date: ___________
Save the receipt, warranty and these instructions. It is important that you read the entire manual to become familiar with this
product before you begin using it. This product is designed for certain applications only. OEMTOOLS
®
cannot be responsible
for issues arising from modification. We strongly recommend this product is not modified and/or used for any application other
than that for which it was designed. If you have any questions relative to a particular application, DO NOT use the product until
you have first contacted customer service to determine if it can or should be performed on the product.
WARNING: This product can expose you to chemicals, including acrylonitrile, which are known to the State of California
to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Explanation of Safety Signal Words
WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.
CAUTION: Used without the safety alert symbol indicates a potentially hazardous situation which, if not avoided, may result
in property damage.
NOTES: Provide clarity and helpful information.
WARNING
11/18
2018 OEMTOOLS
™
To Next Page
Need help?
General