WARNING
The following safety information is provided as a guideline to help you operate your Engine Stand under the safest possible conditions. Any
tool or piece of equipment can be potentially dangerous to use when safety or safe handling instructions are not known or not followed. The
following safety instructions are to provide the user with the information necessary for safe use and operation. Please read and retain these
instructions for the continued safe use of your Engine Stand. Failure to follow instructions listed below may result in serious injury. In addition,
make sure that anyone who uses the equipment understands and follows these safety instructions as well.
Explanation of Safety Signal Words
WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.
CAUTION: Used without the safety alert symbol indicates a potentially hazardous situation which, if not avoided, may
result in property damage.
NOTES: Provide clarity and helpful information.
Thank you very much for choosing an OEMTOOLS
®
Product!
For future reference, please register your new tool at www.oem-tools.com and complete the owner’s record below:
Model: _______________ Purchase Date: ___________
Save the receipt, warranty and these instructions. It is important that you read the entire manual to become familiar with this product before you begin
using it. This product is designed for certain applications only. OEMTOOLS
®
cannot be responsible for issues arising from modification. We strongly
recommend that this product is not modified and/or used for any application other than that for which it was designed. If you have any questions relative
to a particular application, DO NOT use the product until you have first contacted customer service to determine if it can or should be performed on the
product.
WARNING: Pursuant to California Proposition 65, this product contains chemicals known to the state of California to cause cancer and birth
defects or other reproductive harm. Wash hands after handling.
Operating Instructions and Parts Manual 24829
Please read and save these instructions. Read through this owner’s manual carefully before using product. Protect yourself and others by observing
all safety information, warnings, and cautions. Failure to comply with instructions could result in personal injury and/or damage to product or property.
Please retain instructions for future reference.
1
3/22
2022 OEMTOOLS
®
FOR CUSTOMER SERVICE
Technical Question?
CALL 1-866-458-2472
customerservice@oem-tools.com
UNPACKING
After unpacking the unit, inspect carefully for any damage that may
have occurred during transit. Check for loose, missing, or damaged
parts. If any damage is observed, a shipping damage claim must
be filed with the carrier. DO NOT use the OEMTOOLS
®
24829
1,250 Lb. Large Engine Stand if broken, bent, cracked or damaged
parts (including labels) are noted. Any Engine Stand that appears
damaged in any way, operates abnormally or is missing parts should
be removed from service immediately. If you suspect that the Engine
Stand was subjected to shock load (a load that was dropped suddenly,
unexpectedly, etc.) Immediately discontinue use until it has been
checked by a factory authorized service center.
1,250 LB. LARGE ENGINE STAND
To Next Page
Need help?
General