SECTION VII
MAINTENANCE SCHEDULES
EVERYDAY MAINTENANCE:
1. Check hydraulic oil level and make sure it is within 2” of the top of the
tank
2. Torque wheel lug bolts to 100 ft. /lbs. and wheel hub nuts (axle nuts) to
at least 200 ft./lbs.
3. Inspect all hydraulic components and hoses for leaks and correct leaks
immediately
EVERY 100 HOUR MAINTENANCE:
1. Grease front caster wheel assemblies (2 places to grease) and inspect for
damage
2. Grease blade bar shaft (behind blade holder assembly)
3. Check and tighten all hydraulic fittings
4. Inspect and tighten all joystick steering linkages
5. Equalize the battery pack by charging to 100% then unplugging power
source and plugging back in to start another charge cycle until
complete.
EVERY 250 HOUR MAINTENANCE:
1. Drain and replace hydraulic oil and filter
BE AWARE OF THE EFFECTS OF HARSH ENVIRONMENTS TO
THE SCRAPER EQUIPMENT.
A. The constant and continuous impacts of ceramic tile removal
could cause premature loosening of bolts and nuts over the entire
machine
B. Use of non-marking (white) tires on ceramic tile, marble, or
sharp-edged debris will result in extreme tire damage. Black tires
are recommended
C. Carpet removal will generally result in front transport casters
being wrapped with stray carpet strings. Remove debris from
front and rear wheels daily to prevent irreparable damage to
bearings and seals.
To Next Page
Loading...