3
Operating Instructions and Parts Manual 24503
MULTIPURPOSE DRILL
POWERED PUMP
• Before use, read and understand all warnings, safety
precautions, and instructions as outlined in the
vehicle manufacturer’s service manual. It is beyond
the scope of this manual to properly describe the
correct procedure and test data for each vehicle.
• Always perform vehicle service in a properly
ventilated area. Never run an engine without proper
ventilation for its exhaust. Stop work and take
necessary steps to improve ventilation in the work
area if you develop momentary eye, nose, or throat
irritation as this indicates inadequate ventilation.
• Engine parts that are in motion and unexpected
movement of a vehicle can injure or kill. When
working near moving engine parts, wear snug fit
clothing and keep hands and fingers away from
moving parts. Keep hoses and tools clear of moving
parts. Always stay clear of moving engine parts.
Hoses and tools can be thrown through the air if not
kept clear of moving engine parts. The unexpected
movement of a vehicle can injure or kill. When
working on vehicles always set the parking brake or
block the wheels.
• Be alert for hot engine parts to avoid accidental
burns.
• If you drove your car recently, fluids could be very
hot. Allow at least 2 hours before you handle any
fluids. Oil and Coolant burns are very dangerous.
• Avoid accidental fire and/or explosion. Do not smoke
near engine fuel and battery components.
• The warnings, precautions, and instructions
discussed in this manual cannot cover all possible
conditions and situations that may occur. The
operator must understand that common sense and
caution are factors which cannot be built into this
product, but must be supplied by the operator.
• For safety purposes and the prevention of damage
to expensive components it is advised that the user
have an understanding of basic automotive repair
and a working knowledge of automotive systems.
• We believe the information contained herein to be
reliable. However, general technical information is
given by us without charge and the user shall employ
such information at his own discretion and risk. We
assume no responsibility for results or damages
incurred from the use of such information in whole
or in part. Always refer to specific instructions
and technical information supplied by vehicle
manufacturer.
• The manufacturer declines any and all responsibility
for damage to vehicles or components if said
damage is the result of unskillful handling by the
operator or of failure to observe the basic safety
rules set forth in the instruction manual.
DISPOSAL
At the end of the useful life of the Drill Powered Pump,
dispose of the components according to all state,
federal, and local regulations.
PURPOSE
Designed to be used in combination with a corded
or cordless drill to transfer the following liquids: fresh
water, sea water, organic solvents, motor oil, heating
oil, insecticides, and liquid fertilizers.
It is the pump owner’s responsibility to properly
handle, recycle and dispose of products and ensure
that those who use this Drill Powered Pump to
transfer fluids do so in a safe and environmentally
responsible manner.
Be sure to follow the liquid manufacturer’s or
supplier’s recommendations for safe storage and
handling.
Ensure that all containers of liquids are properly
marked.
Never use with concentrated acids or volatile,
flammable liquids such as gasoline, nor with liquids
which leave residue or solidify on drying.
When using a Corded Drill make sure to avoid
contact with liquids as an electrical shock hazard
may exist.
Be aware that sparks from a Drill Motor can serve
as an ignition source for flammable or explosive
vapors.
03/14
2014 ©OEM-TOOLS
WARNING
To Next Page
Loading...