Ofs ELEVEN WOOD User Manual

PART # 1609141
CORNER LEGS
INSTALLATION INSTRUCTIONS
ELEVEN WOOD
1. Begin by removing the hex nuts and flat washers from the threaded studs
on each of the table legs. Attach the leg to the frame assembly by inserting
the threaded studs into the corresponding holes in the frame as shown in
the view above.
2. Next, re-attach the flat washer and hand tighten the hex nut onto the
threaded stud. Repeat the previous steps for the remaining table legs. To
complete the assembly, fully tighten all the hex nuts using a 1/2" wrench.
NOTE: Views shown without the
worksurface for clarity purposes.
THREADED STUD
HEX NUT
FLAT WASHER
FRAME

Ofs ELEVEN WOOD Specifications

General

Brand	Ofs
Model	ELEVEN WOOD
Category	Indoor Furnishing
Language	English

Summary

Corner Legs Installation

Attach Legs to Frame

Remove hex nuts/washers, insert threaded studs into frame holes, and attach legs.

Tighten Hex Nuts

Re-attach flat washers and hand-tighten hex nuts. Fully tighten with a 1/2" wrench.

66" Round and Square Tables Assembly

Attach Legs to Frame Assembly

Insert threaded studs from legs into frame holes, then attach.

Tighten Leg Hex Nuts

Re-attach washers and hex nuts, hand-tighten, then fully tighten with a 1/2" wrench.

Secure Frame to Worksurface

Position frame centered on worksurface, ensuring equal dimensions, and fasten with screws.

End Leg Installation

Insert Cross Dowel and Threaded Rod

Insert cross dowel into leg hole, then insert threaded rod and fasten halfway.

Attach Legs to Frame Rails

Align leg holes with frame rail pins, insert threaded rod, attach washer and flange nut.

Mount Frame to Worksurface

Ensure frame is centered and fasten to the worksurface using supplied screws.

End Leg with Extensions Installation

Install Cross Dowel and Threaded Rod

Insert cross dowel into extension, then insert threaded rod and fasten.

Attach Extensions to Legs

Align leg holes with extension dowel pins and insert threaded rod.

Connect Legs to Frame Rails

Align leg/frame holes, locate pockets, attach washer and flange nut, then tighten.

Secure Assembled Frame

Verify frame centering and fasten to the worksurface with screws.

Intermediate Legs Installation

Prepare Extension with Cross Dowel

Insert cross dowel into extension, align slotted end, insert threaded rod, fasten.

Connect Extensions to Legs

Align leg holes with extension dowel pins and insert threaded rod.

Attach Legs to Frame Rails

Align all holes, locate 'D' pockets, attach washer and flange nut, tighten.

Mount Frame to Worksurface

Ensure frame centering and fasten to the worksurface using supplied screws.

Foot Rail Assembly

Attach Cross Dowel and Mount Puck

Insert cross dowel and screw into mount puck, aligning with cross rail holes.

Assemble Frame and Secure Foot Rails

Align frame rails onto legs, insert foot rails onto mount pucks, then secure with screws.

Foot Rail Assembly for Two-Piece Top

Attach Cross Dowel and Mount Puck (End Legs)

Insert cross dowel and screw into mount puck, aligning with end leg cross rail.

Attach Mount Puck and Hex Nut (Intermediate Legs)

Insert threaded stud into intermediate leg, attach mount puck and hex nut.

Assemble Frame and Secure Foot Rails

Align frame rails and foot rails onto legs, then secure with screws.

Library Tackboard Installation

Install Mount Pins

Insert mount pins into worksurface holes, ensuring correct orientation, and fasten.

Install Tackboard

Align tackboard holes with mount pins and slide into position. Optional standoff slides on first.