⚫ Use of distilled or de-mineralised water is recommended to prolong the life of the
steamer.
⚫ Use water only; do not use detergents or other chemical substances.
⚫ Mis-use will lead to an invalid guarantee.
Steaming Linens and Fabrics
⚫ Ensure the water tank has been filled and that the desired accessory is connected and
then follow the steps below
⚫ Plug the unit into the mains power supply and switch On if switchable.
⚫ Switch the unit On to indicate the appliance is on.
⚫ Steam will emit from the nozzle after approximately 130 seconds.
⚫ Direct the steam nozzle with either one of the accessories towards the material you wish
to steam.
⚫ Keep the flow of steam focused on the material being steamed.
⚫ Using a slight back and forth motion over the area you are steaming will further enhance
the process.
⚫ CAUTION: Always be sure that the Steam Nozzle and any other attachments are pointed
in a safe direction away from the user, other people and animals when steam is being
emitted.
Steaming Garments
⚫ Place the garment on a clean rust-free hanger.
⚫ Direct the steam nozzle towards the bottom of
the garment.
⚫ Steam will rise on both the inside and outside of
⚫ the fabric removing the wrinkles and creases.Slowly
slide the steam nozzle
⚫ upwards from the bottom to the top of the garment.
⚫ Direct the steam nozzle away from the garment and smooth the fabric with your free hand
⚫ Repeat as necessary until the garment is crease-free.
Storage
⚫ Unplug the power cord from the mains power supply.
⚫ Allow the unit to cool thoroughly (at least 60 minutes).
⚫ Remove all attachments from the unit.
⚫ Drain the remaining water from the water tank to minimise potential mineral build-up.
Loosely replace the water tank cap but do not tighten as it may be difficult to unscrew for
To Next Page
Loading...