Ohlins TTX25 - Page 14

14
15
5.9
Put the O-ring on the Adaptor and install the Adaptor. Use
Assembly lubricant on the O-ring. Clean the thread and apply
Loctite.
Tightening torque 40 Nm
Loctite 243
5.10
Remove tool 02810-01, 01797-05 and 01765-03.
5.11
Use tool 01781-01. Fill gas to 6 Bar.
5.12
Mount the Adjustment rod in the Shaft.
5 FILL OIL
5.10
5.12