ohmex FND 1000 - Page 57

EN
FND 1000
53
USE
Do not ll the pot more than 80% of its maximum capacity (max
2,0 l); this to avoid that the content overows, risking to cause
scaldings or burns.
Do not use the pot if its
content is lower than the
“MIN” indication.
• Place the ring with the forks slots (4) on the pot (3).
• The appliance is ready for use.
• Unroll the electrical power cord (8) completely.
• Turn the thermostat (7) on “0”.
• Connect the power plug to the power socket making sure that the mains power
corresponds to the one indicated on the appliance rating label.
• Turn the thermostat (7) on the maximum temperature (MAX).
• The indicator light (8) turns on (heating phase) and then turns o when reaching the
set temperature (appliance ready).
During the rst use of the appliance a light smoke emission accompanied
by a particular smell could occur. This is a normal phenomenon which
will automatically disappear.
Prepare an appropriate ventilation.
Do not move the appliance when it’s hot.
If it’ll be necessary to move it, operate extremely carefully,
holding it only from the appropriate handles (2).
Danger of burns or scaldings !
Use the little forks carefully: once left in the pot their metallic
part overheats.
Burns danger!
☞
☞
☞
MAX
MIN