63
PAS 2200
EN
9. Place the locking ring onto the pasta attachment and screw it clockwise to tighten it
(Fig. G).
10. Place the mixing container lid onto the mixing container in such a way that the tab
on the back part of the lid ts into the recess on the motor unit.
11. Turn down the lid so that the two pins on the rear edge of the lid are guided through
the slots in the mixing container into the motor unit (Fig. I).
12. Press down the mixing container lid until it locks in place. The device has
a safety switch. This is located inside the motor unit and is activated by a pin on the
mixing container lid. The device can only be switched on using the ON/OFF switch if
the mixing container lid is placed on correctly and the pin activates the safety switch.
> > Use
• Make sure that the ON/OFF switch (4) is in the OFF position before you connect the
device to the mains power.
• The appliance is equipped with a safety switch, located inside the motor unit, which
is activated by a stop located on the lid of the container.
It is possible to switch on the appliance only using the ON/OFF switch (4) if the cover
is positioned correctly and if the stop activates the safety switch.
If the stop on the cover is damaged, do not try to activate the
safety switch nor to bypass/repair it using your hands.
In the presence of defects, please contact the customer service.
It is advised not to use the appliance until it has been repaired.
Do not overll the mixing container! Excessively large quantities
of ingredients may cause damage to the device. Larger quantities
should be spread between two or more kneading operations. The
ll level per operation should not be more than approx. 400 g.
Do not operate the device for more than 15 minutes without
interruption! Operating the device continuously for too long
may cause damage to the device. Switch the device o after 15
minutes and let it cool down for a few minutes before you switch
it back on again.
USE
To Next Page
Loading...