What to do if there is high-press in HC operation in my Oilon RE 35 Heat Pump?
If your Oilon Heat Pump's compressor reaches maximum pressure on the pressure side during Heating Circuit operation, adjust the maximum temperature for outgoing water to a lower setting.
What to do if the Oilon Heat Pump shows a condenser difference max limit?
If the temperature difference over the condenser in your Oilon Heat Pump is too high, check the heating circuit venting and increase the pump rotation speed.
What to do if the source temp is too low in my Oilon Heat Pump?
If the ground circuit temperature is too low, vent the ground circuit and ensure the pump rotation speed is at maximum in your Oilon Heat Pump.
What to do if the Oilon RE 35 Heat Pump displays an evaporator difference max limit?
If the temperature difference over the evaporator is too large, check the ground circuit venting, increase the pump rotation speed, and check the screen of your Oilon Heat Pump.
What to do if the Oilon RE 35 shows a condenser difference min limit?
If the temperature difference over the condenser in your Oilon Heat Pump is too low, slow down the pump rotation speed.
What to do if the Oilon RE 35 displays an evaporator difference min limit?
If the temperature difference over the evaporator is too small, check the compressor operation of your Oilon Heat Pump.
What to do if compressor 1 is overloaded in my Oilon RE 35?
If your Oilon Heat Pump displays 'Compressor 1 overloaded', call service and check the motor overload protection setting data.
What to do if compressor 2 is overloaded in my Oilon RE 35?
If your Oilon Heat Pump displays 'Compressor 2 overloaded', call service and check the motor overload protection setting data.
What to do if there is no measurement from hot-gas sensor 1 in Oilon RE 35?
If there is no measurement from the hot gas sensor, check the hot gas sensor measurement connection on your Oilon Heat Pump.
What to do if there is no measurement from the source inlet sensor in my Oilon RE 35?
If there is no measurement from the source inlet sensor, check the source inlet sensor on your Oilon Heat Pump.
To Next Page
General