EasyManuals Logo

OJ Electronics WLM2 User Manual

OJ Electronics WLM2
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
27
Domestic hot water control
It is possible to control the domestic hot water temperature with a special version of the WLCT2, called
WLCT2-X9/HW) to ensure optimum energy saving.
A hot water sensor is connected to the controller and measures the temperature in the storage cylinder.
To change the temperature of the domestic hot water, just change the set point in
the WLCT2-X9/HW by using the up or down button.
The 4-event system in the WLCT2-X9/HW can be used to save energy when hot water
is not needed..
Radiator control
It is possible to control a radiator circuit room temperature with a special version of the WLCT2 called
a WLCT2-X9/R) to ensure optimum energy saving.
The controller measures the temperature in the room, and a zone valve is then controlled via the WLM2
master, which in turn activates the boiler on demand.
To change the temperature of the radiator circuit , just change the set point in the WLCT2-X9/R
by using the up or down button.
The 4-event system in the WLCT2-X9/R can be used to save energy when heat is not needed.
2 step heating
A special version of the WLCT2 called WLCT2-X9/2 is capable of controlling an additional heat source
in a room. In addition to the primary under fl oor heating output, the room controller is now able to
control a second output as a boost function, which will be activated only if the temperature cannot be
achieved by the primary under fl oor heating output within a preset time period.
The Room Controller is used as a standard WLCT2.
If required the settings for when the second heating output is needed can be changed in the service
menu in the WLCT2-X9/2.
An additional Menu entry “2 st” can be found.
In this menu two parameters can be changed:
Temp: If the actual room temperature is higher than the setpoint minus this setting, the second
output will not be activated.
Time: This parameter decides how long the actual temperature is allowed to remain below the
setpoint minus the TEMP setting before the second output is activated.
WLCT2/HW
WLCT2/R
WLCT2/2
Type WLCT2 (and WLCT2/R/HW/2)

Other manuals for OJ Electronics WLM2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the OJ Electronics WLM2 and is the answer not in the manual?

OJ Electronics WLM2 Specifications

General IconGeneral
BrandOJ Electronics
ModelWLM2
CategoryThermostat
LanguageEnglish

Related product manuals