OK. OCR 100 - Installation and Setup; Clock Setup; Basic Operation; Product Features

13
eN
INSTALLATION
1
Place the product on an even, horizontal and steady surface.
2
If desired, two batteries can be inserted so that in the event of a power failure, settings are
maintained. Open the battery compartment by removing the cover. Insert 2 batteries type AAA/
LR03 (not included). Pay attention to the correct polarity (+/-) according to the imprint in the
battery compartment. Close the battery compartment cover.
3
Put the end of wire aerial up to receive at best signal strength. Connect the power plug to the
mains.
CLOCK SETUP
Clock setting is only possible in Standby/ OFF mode.
1. When product is connected with mains the rst time, 0:00 will be shown on the display in standby
mode.
2. If needed turn o the radio by pushing power button
for approx. 2 seconds. Press and hold CLOCK
for 2 seconds.
3. Use the VOL/TUNE volume control to set the 12H or 24H hour format and press CLOCK to conrm.
4. Now set the hours with the volume control VOL/TUNE and conrm with CLOCK.
5. Now set the minutes with the volume control VOL/TUNE and conrm with CLOCK.
6. The setting has now been completed.
OPERATION
Switching ON and OFF
4
Press power button
to switch on. For switching o, press power button for at least 2 seconds.
Mode selection
5
Press the SOURCE button to select mode in order FM radio, AUX (Audio in), CD and USB (USb).
Volume control
6
The loudspeaker volume can be easily controlled by turning the volume control VOL/TUNE. The
volume is shown in display for a moment.
XBASS function
Press the XBASS button to raise the bass. Press again to stop the function.
7
Timer or short-circuit function
• This function is only available when the radio is switched o.
• Press the NAP button. The default time is 10 minutes. If necessary, use the volume control to set
the time in minutes. Conrm the set time and activate the timer by pressing the NAP button
again. When the set time has elapsed, an alarm sound turns on. Press the NAP or power button
to stop the alarm.
IM_OCR100_170907_V03_HR.indb 13 7/9/17 3:04 pm