www.okinternational.com - 33 - P/N 7000-1370, Revision B
11. Replace camera shield.
12. When the image is centered, tighten the camera lock-down screws located
underneath the front part of the camera (screws identified in step 10 above).
13. The final image should have the vacuum cup centered in the software window.
Now the vacuum head is central to the camera.
X-axis
adjustment
screws.
Note: When adjusting X-axis make to adjust booth screws per side equally.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...