Why does my Oki Printer emit odors?
Odors from your Oki Printer are often caused by gases given off by forms or adhesives passing through the hot fusing unit. Ensure the forms you use can withstand heating, and provide adequate ventilation.
How to resolve feed jam or exit jam on Oki Printer?
To resolve a feed or exit jam on your Oki Printer, remove the tray and clear any misfed sheets. Open the top cover, carefully lift out the image drum (with the toner cartridge), and remove any jammed sheets from the paper path. Re-install the image drum with the toner cartridge, close the top cover, and latch it closed. The printer will warm up and start printing. If the paper edge protrudes from the exit, reinstall the image drum, close the top cover, and switch the printer on. Remove the jammed paper when the exit roller rotates. If you still can't remove the paper, contact a service representative.
What to do if my Oki Printer prints blank sheets?
If your Oki Printer is printing blank sheets, it could be due to the image drum cartridge not being properly installed. Try reinstalling the image drum cartridge. Another possible cause is an empty or missing toner cartridge, so install a new toner cartridge.
Why is my Oki Printer printing faded print?
If your Oki Printer's print is faded, it may be because the toner cartridge is not correctly installed or the toner is low. Try installing the toner cartridge correctly or replacing it with a new one.
Why does Oki Printer warm up before printing?
If your Oki Printer is on but needs to warm up before printing, it's because Power Save mode is enabled to conserve energy. The fuser needs to heat up before you can begin printing. To eliminate the warm-up delay, change the Power Save setting.
Why is Oki Printer’s output below rated speed?
If your Oki Printer's output is slower than its rated speed, the application you're using is likely the cause of the delays. For maximum speed, use text in your document and use a printer resident font.
Why do pages curl excessively from Oki Printer?
Excessive curling of pages from your Oki Printer can be due to several reasons: you might be printing on the wrong side of the paper, so turn the paper over in the tray, installing it print side down. Moisture in the paper or improper storage can also cause this, so avoid storing paper in areas of excessive temperature and humidity and keep it in protective wrapping. High humidity can also be a factor; the recommended operating humidity is 20-80%.
Why is my Oki Printer printing garbled output?
If your Oki Printer is producing garbled output, it's likely that an incorrect driver is installed. Install an appropriate driver for your printer model.
How to fix oblong area of faint print on Oki Printer?
An oblong area of faint print on each page from your Oki Printer is likely due to using paper exposed to high humidity. Try changing paper stocks, checking the paper storage environment, or using a dehumidifier; also, check the toner level.
What to do if Oki Printer prints all black?
If your Oki Printer is printing all black pages, it indicates a hardware problem. Contact service.
General| Paper Capacity (Standard) | 250 sheets |
|---|---|
| Processor | 266 MHz |
| Memory (Standard) | 32 MB |
| Memory (Maximum) | 288 MB |
| Compatibility | Windows, Mac, Linux |
| Function | |
| Print Resolution (Black) | 600 x 600 dpi |
| Connectivity | Ethernet, USB |
| Monthly Duty Cycle | Up to 50, 000 pages |
| Printer Language | PCL 6, PCL 5e, PostScript 3 |
| Type | Laser Printer |
To Next Page
