Setting the security > 14
IPS
EC
To enable IPSec encryption:
1. From the left hand panel select IPSec.
2. From the drop down menu select ENABLE.
3. Enter valid IP Addresses in the STEP2. IP Address Settings table.
4. Update the Phase 1 Proposal Settings as required.
5. Enter the Pre-Shared Key Settings (max. 64 characters).
6. Update the Key PFS Settings as required.
7. Update the Phase 2 Proposal Settings as required.
8. Click Submit to save the changes or Cancel to exit.
To Next Page
Loading...
Need help?
General
