Menu functions > 45
Power setup
Language setup
Print statistics
ITEM SETTINGS EXPLANATION
Peak Power Control Normal
Low
Sets Peak Power Control level.
Power Save Enable
Disable
Sets Enable/Disable of Power Save Mode.
If Power Save is disabled, pressing the Power Save /
Wake Up button on the control panel will manually
override this setting.
Sleep Enable
Disable
Sets Enable/Disable of Sleep Mode.
USB Host Power Off
On
Set power supply for USB-HOST of the whole power save
mode.
When Off, suppress power supply.
When On, do normal power supply.
ITEM SETTINGS EXPLANATION
Language Initialize Execute Initialises the message file loaded in FLASH.
When you press the Enter button, the following
message, requesting confirmation, will appear,
Are You Sure?
Yes
No
If NO is selected, you will be returned to the source
menu.
The procedure for clearing the disk will start immediately
after the menu and rebooting.
ITEM SETTINGS EXPLANATION
Enter Password **** Enters a password to enter Print Statistics menu.
The default value is “0000”.
The password for entry to Print Statistics is different
from the password for entry to Functions-Admin Setup.
“Print Statistics” category is not shown when Print
Statistics function is not supported.
Usage Report Enable/Disable Enables/Disables the printing of the Usage Report.
When changing a setting value, the printer is rebooted.
Group Counter Enable/Disable Specifies if the Group counter is displayed in the Usage
Report Print.
Enable: Displayed,
Disable: Not displayed.
Conditions for display:
Enable must be selected in Print Statistics > Usage
Report.
To Next Page
Loading...
